Product Overview
Dinosaur Electric Fan 50 Plus Ignition Control Board (FAN 50 PLUS PINS) Replaces 521099
Attributes
- Compatibility: Replaces Dinosaurs Earlier Small And Large Fan Boards
- Voltage: 12 Volt
- Length (IN): 4-1/4 Inch
- Width (IN): 3.35 Inch
Works with models:
DD-17-DSI / NT-12S / NT-12SE / NT-16S / NT-20S / NT-16SE / NT-20SE / NT-24S / NT-24SP / NT-24M / NT-25K / NT-30SP / NT-34S / NT-42T / SF-20 / SF-20F / SF-25 / SF-25F / SF-30 / SF-30F / SF-35 / SF-35F / SF-42 / SF-42F
SF-20Q / SF-20FQ / SF-25Q / SF-25FQ / SF-30Q / SF-30FQ / SF-35Q / SF-35FQ / SF-42Q / SF-42FQ
SF-20VHQ / SF-25VHQ / SF-30VHQ / SF-35VHQ / SF-42VHQ / SF-20VHFQ / SF-25VHFQ / SF-30VHFQ / SF-35VHFQ / SF-42VHFQ
Product Description
The FAN 50 Plus Pins is designed to replace the new Suburban® and Atwood® / HydroFlame® Fan Control boards as well as maintain backward compatibility with the Fan 50 Plus, and UIB Fan Control boards which have been available since 1994. This board can also be used to upgrade older furnaces to add the Fan Control feature. The basic purpose of a Fan Control Ignitor Board is to shut the fan motor off if the board fails to sense a flame after the third ignition try. Thus, battery drain is reduced and the needless blowing of cold air is eliminated.
- Used To Upgrade Older Furnaces To Add The Fan Control Feature
- Shuts The Fan Motor OFF If The Board Fails To Sense A Flame After The Third Ignition Try
- Battery Drain Is Reduced And The Needless Blowing Of Cold Air Is Eliminated
- Compatible With The Fan 50 Plus And UIB Fan Control Boards
- Limited 3 Year Warranty
Questions & Answers
Questions & Answers
Popular Questions
7 months ago
I have a NT-16SE furnace that was built in 1998 and it only has 3 wires going to the edge connector, common, gas valve and 12vdc. Can I use this board? Thanks See more »
Reviews
(1 review)
Write a Review
1 Review Hide Reviews Show Reviews
-
2 suburban heater control board
Posted by Ken Atwater on Feb 25th 2025
didn't fit in holder, couldn't use
